www.fastmarinamagazine.com

7/16 UNF more than likely if a 10cwt could be a old BSF thread due to age of rear axle my best bet would be 7/16 though
Dave

]In the Hazard warning light switch there is changeover contacts that allow all four lights to light at the same time when in on position and switch to single side light when switched off it also switches the flasher unit between constant live hazard and ignition live indicators when switch is activ...

Pre engaged would be the way to go. My MGB has one fitted as does the late 1.7 Ital I have for parts. To build up the 2.0 for the planned engine conversion on my Brown Coupe. One thing of note is the Inertia starter engages from the back of the flywheel, whereas the Pre engaged engages from the fron...

I have heard the wiper lifting story before. Not sure I really believe it myself. The early cars that had RHD did indeed have the wipers the correct way around. The shell already had holes punched in scuttle for both LHD and RHD the holes were even in both flitches for wiper on either side the holes...

What I would do in the absense or a rolling road is set it to 25deg BTDC at 2500 without vacuum then road test the car puling away 30-50 mph at full throttle knocking the timing back in 2 deg incruments untill the engine stops pinking. This will give you ignition timing just about optimum for your s...

Having checked my Current Gates Catalogue 1.3 Marina with manual transmission and alternator ( MORRIS MARINA SALOON 1,3 10/78-10/80 E) should be a 6271MC belt which translates to 10 x 838mm measured on its inner face from the Unipart number listed GCB10813 you have a cogged belt of 10mm wide by 813 ...

If I find the table for on off fan switch temps I will add later
Dave

Sherpa Radiator core is what I use with the later Ital shielding removed mecanical fan and electric pusher fan fitted with temp switch off a Peugeot
Dave

Assuming earthing the signal wire from the gauge sender with ignition on gauge shows full fault lies in sender unit. The sender unit itself can also suffer from a poor earth as earth is only provided by the lock ring. Clean off a section of the metal pipe on sender unit attach a extra earth wire wit...

Think I bought it off ebay from memory listed for a Land Rover
Dave

Have thought about cutting the floor section out of a Scrap Tr7 I have, to give a similar arangment. A lot of work. Same could be achived by fitting a Phannard Rod or Watts Linkage Fuel tank does sit close to rear axle though. I currently run MK1 Escort lowering blocks moified to fitthe Marina Sprin...

What Steering angle are you trying to adjust is it Camber or Castor
Dave

Charged the battery of my Brown Coupe at the weekend go her going found the brakes and clutch were all free Time to give her a service now grease the suspension and a good cleaning ready for some early spring evenings soon
Dave

Yuasa batteries give me all sorts of headaches at work on modern cars wouldnt have one uless no other choice NAPA battery gives a good warranty new in the UK common in the States though
Dave

Dewalt Gun very impressive!! I got the full range 3/8, 1/2, & 3/4 drives you will be well impressed with that the hub puller looks FAB as well made a slide hammer adaptor for mine and used it to slide hammer out halfshafts as well
Dave